The 8 Best In Floor Hot Water Radiant Heat Panels

Our distribution panels simplify your radiant heat installation. They have all the necessary components to operate radiant systems and pass all known building codes. On-site work will be minimized to connect your supply and return lines to the boiler and manifolds, electrical wiring and providing make-up water supply. No soldering is required.The 1″ copper tubing is large enough to accommodate both large and small projects. All panels are pressured tested prior to leaving our facility and are carefully packaged to assure safe delivery.

Product Description

This Smart Technology electric tankless water heater is configured as a “whole home” model for climates where incoming water temperature is 62°F and above. The ECO 18 is capable of heating over 2.5 gallons per minute, which is the equivalent of one water saver shower head (with a 1.5 gpm flow) and one sink with a low inlet water temperature of 62°F, and an output setting of 105° F. Two showers emitting no more than 1.5 gpm each can be run simultaneously when incoming water temperature is above 70° F. Digital temperature control allows you to set your temperature in increments of 1°. All tankless water heaters are sized based on flow rate and temperature rise, and there is a direct relationship between the two. So if used in a cold area requiring a high temperature rise, it will be more limited in the amount of fixtures (gallons per minute) it can heat at one time compared to a warmer climate. However, when sized properly it will provide endless hot water and only consume the energy needed, giving the user complete control. Prior to purchase and installation please verify this model is the right size for the expected demand and electrical requirements. The ECO 18 requires a minimum 150 amp electrical panel for installation with (2) 40 amp double pole breakers connected to (2) sets of #8 awg wire. Plumbing connections are 3/4″ NPT. For additional assistance please feel free to contact our support center at 877-474-6473.

From the Manufacturer

This Smart Technology electric tankless water heater is configured for climates where incoming water temperature is 62 Degree F and above. The ECO 18 is capable of heating over 2.5-Gallon per minute, which is the equivalent of one shower head (with a 1.5 gpm flow) and one sink with a low inlet water temperature of 62 Degree F. Two showers can be run simultaneously when incoming water temperature is above 70 Degree F in warmer climates such as South Texas, South Florida, New Mexico, Arizona and South California. These models come with a digital temperature control that allows you to set your temperature in increments of 1 Degree. Prior to purchase and installation please verify this model is the rights size for your hot water needs and electrical requirements.

Product Details
Model: RS15-6
Rated Power: 93/67/46W 
Outlet: 3/4 inch 
Max Flow: 36/29/20L/min
Rated Head: 20/16/13m
Volt/Freq: 110-120V/60Hz

Applications
Used in Suitable for city buildings, suburban villas, houses, water and pressurized with industrial equipment, air conditioning, boilers, solar circulating water, hot water circulating warm and so on

Advantages
1.High efficiency, high flow, leak-tightness, low consumption
2.No noise environmental protection, ease of installation
3.No leakage, low noise, environmental protection, aesthetics, ease of installation and so on
4.Built-in high sensitive electronic sensors with three-speed control

Performance Datas
1) Suitable for medium: Hot water and ethanol maximum ratio of 1:1
2) Performance: Liquid temperature range: 0℉ – +212℉Maximum working pressure 10bar
3) Ambient temperature: not higher than 40
4) Voltage: 110-120V(±10%) ,Frequency: 60Hz.
5) Motor: Protection class IP44 Insulation class F
6) Material: Stainless Steel, PP, ceramics
7) Mounting position: Shaft horizontal mounting
8) Pump settings: Single-phase pipeline pump 3 files manually controlled single-phase motor is not overloaded casting pump length 130 mm

Mr Radiator Wall Mounted Radiator Heaters are best solution for staying warm and cozy within your home. They provide you with Fast Heating and also Save Energy with their Two Conductor Operation, all while hanging conveniently on your wall. They can be mounted virtually anywhere, even in places where you may not have that much space.

Mr Radiator Wall Mount Radiator Heaters are Reliable, Durable and Safe, made with focus on quality and ease of use. Every Mr Radiator Wall Heater passes through stringent quality controls to ensure Complete Customer Satisfaction.

Features :-

• Versatile, Compatible with Hydronic Hot Water Systems
• Expandable, Additional Sections can be installed for Future Heating Needs Easily by Wrench
• Easy to Install , Connects with PEX Tubing, Copper, Polybutylene and CPVC Piping
• Powerful Heating, 2574 BTU on Hydronic Systems
• Energy Saving, Immediate Efficient Heating Operation with Two Separate Heat Conductors
• Premium Coating, High Quality Scratch Resistant Powder Coating for Long Life
• Sleek Looks, Exclusive Curved Design easily blends with any Decor
• Technical Specifications : –
  • Body Material : Aluminum
  • Core Material : Stainless Steel
  • Core Material : Stainless Steel
  • Maximum Working Pressure : 435 Psi
  • Tested Working Pressure : 870 Psi
  • BTU per Section : 429 BTU Per Section on Hydronic Systems

Includes:-
Radiator Water Heater
Installation Kit i.e Straight Radiator Valve and Bushing Kit

Mr Radiator, Leading Wall Radiator Heater Brand in the Market , Focused on Quality for Long Lasting and Convenient Products.

Conclusion

By our suggestions above, we hope that you can found in floor hot water radiant heat panels for you.Please don’t forget to share your experience by comment in this post. Thank you!